Fixture-grade electrical, inside the lighting project.
Offered exclusively as part of a lighting-control system project — not as a standalone electrical service.
Licensed #197483 Where the lighting design stops being a drawing.
Architectural lighting asks more of the electrical work than a standard fit-out does. Cove details, edge-lit millwork and backlit stone depend on drivers being reachable, circuits being grouped the way the scenes expect, and fixtures being trimmed and aimed after the finishes land. Handled as a separate trade, that coordination is where the design quietly degrades.
So on lighting-control projects we take that portion of the electrical work ourselves and carry it through to the tuned result. One party is responsible for the fixture, the driver, the circuit and the scene it belongs to.
Every project includes
- Fixture-grade electrical within the lighting-control scope
- Driver, transformer and control wiring
- Circuiting coordinated to the lighting design
- Trim, aiming and level balancing
- Handover with the lighting-control system
How this one is scoped. This service exists only inside a Watt Integration lighting-control project. We do not take it on as standalone electrical work, we do not quote it separately from the lighting system, and we are not a general electrical contractor. If you need electrical work outside a lighting-control scope, we would rather tell you that early than sell you the wrong thing.
The process
How a project runs, and who you speak to.
Scope
Confirmed against the lighting-control design — this work travels with it.
Coordinate
Fixture schedule and circuiting agreed with the designer and builder.
Install
Fixtures, drivers and controls set to the drawing.
Tune
Levels and scenes balanced once the room is finished.
Planning the lighting?
This work is scoped with the lighting-control design, so it belongs in that conversation.
Serving Scottsdale · Paradise Valley · Fountain Hills · Rio Verde · Phoenix